Zep System III

- For flat-roof applications

Zep System III™ from Zep Solar offers the fastest and least expensive way to mount PV arrays on flat roofs. With a series of drop-in and quarter turn connections, Zep System III greatly accelerates the process of commercial rooftop installation. Zep System III eliminates the need for mounting rails, requires very few parts, and simultaneously accomplishes structural and grounding connections. With far less complexity than conventional systems, Zep System III delivers both labor and logistics savings for commercial PV projects.

Components

	Row Connector, 850-1190 The row connector provides a point of attachment for the Front and Rear Legs and creates a rigid connection beween rows. The profile of the Row Connector accepts standard strut nuts for attaching standard strut or brackets for applications that require bracing for seismic and high wind applications.
	Ballast Pan, 850-1141 The Ballast Pan installs, by hand, over the Row Connector and receives ballast blocks to add ballast weight to the system.
	Front Leg, 850-1165 The Front Leg snaps, by hand, into the Row Connectors and receives the Zep Groove of Zep Compatible PV modules. The structural connections are auto-grounding.
	Rear Leg, 850-1188 The Rear Leg rotates, by hand, into the Zep Groove of Zep Compatible PV modules and snaps into the Row Connectors. The Rear Leg automatically establishes east-west module grounding.
	Ground Zep, 850-1172 The Ground Zep provides a point of connection between the PV array and the equipment grounding conductor and also allows for bonding jumpers at thermal breaks. One bonding jumper is required for every east-west run of 24 PV modules. The Ground Zep is ETL Listed to UL467 as a ground bond means.
	Wind Diffuser, 850-1198 The Wind Diffuser is installed on the back side of each row and reduces uplift forces due to wind by redirecting air over and around the array, balancing air pressures across the upper and lower sides of the array.
	Wire Clip, 850-1222 The AC/DC Cable Clip provides a rapid and effective means of securing array wiring by snapping into the Zep Groove and sliding to create the perfect tension. It offers both sleeved and strain-relief connections and is capable of holding both DC and AC (micro-inverter) wiring.
	Diffuser Support, 850-1158 The Diffuser Support provides additional rigidity along the upper edge of the module row and supports the ends of the Wind Diffusers.
	Enphase Connector Bracket, 850-1209 The Enphase Connector Bracket offers a quick and effective means of securing Enphase Energy's Engage Drop Connector directly to the Zep Groove without the use of tools or separate fasteners.